Galmet SGW(S) Maxi 1000, Installation And Operating Manual

© All rights reserved - Galmet Sp. z o.o. Sp. K. 

Installation and Operating Manual / Warranty Card - SGW(S): Maxi / Maxi Plus / M

5

4. Titanium, maintenance-free, active anode

4. Titanium, maintenance-free, active anode

4.1. Pros of the titanium anode

-  reliable, durable protection
-  low consumption of anodes
-  no sludge on the anode
-  not required regeneration
-  guaranteed long-term operation of the tank

1. Titanium anode
2. Potentiostat (AC)
3. Grounded cord

NOTE ! Before installing the anode CORREX, remove existing protective magnesium anode.
1.  Cable supplied bipolar, connecting the anode CORREX and potentiometer plug must not be lengthened. 
2.  A random change in polarity causes the acceleration of corrosion. 
3.  It is recommended to use the socket 230 V in a short distance from the tank.

4.2. Troubleshooting

LED CONTROL

CAUSE

METHOD OF REMOVAL

ON - green colour

-

Anode CORREX working properly. Full 
protection against corrosion.

-

OFF

-

Lack of electricity.

-

Check the voltage 230 V.

ON - red colour

-

Lack of water in the tank.

-

Cables between the electronic part and the 
anode is connected incorrectly.

-

Lack of contact between the ground (tank) 
and the electrical part of the anode.

-

The anode is contacted with the mass of 
the tank.

-

Fill the tank with water.

-

Put the cables at the anode.

-

Check and clean the rust all connections.

-

Properly isolate the anode from the tank.