Page 1 of 2
©GAMPRODUCTS 8/12
FLICKERMASTER DMX8
©
OPERATING INSTRUCTIONS
• DMX or Manual Control
• Available in 120 volt or 220 Volt Models
• Rugged Aluminum Case with Carry Handle
• Recessed Control Panels to Protect Knobs
and Circuit Breaker
• Up to 2000 Watt Capacity
OPERATION INSTRUCTIONS
Apply appropriate power to pigtail. Flickermaster
DMX8© can be supplied with Edison plugs, stage pin,
twist lock connectors or bare wire. The 220V model
is supplied with bare leads - green is ground.
OFF
DIM FLICKER
STROBE
SPEED
SELECT
STATUS
POWER
REMOTE
DIM
INCANDESCENT • FLUORESCENT • LED
MAX LOAD OUTPUT 2000W
LOW LEVEL
2
8
4
6
0
10
2
8
4
6
0
10
2
8
4
6
0
10
REMOTE JACK -
Used to turn Flickermaster DMX8©
on and off from a remote location. See remote jack or
DMX instructions on back page.
STATUS
(Green/Red LED) - When powered, this light
is red and green when DMX is present.
OUTPUT
(Red LED) - Indicates level of output.
Flickers to show flicker/strobing range. In DIM setting,
glow intensity is relative to output level.
BACK PANEL
• Power IN / OUT pigtails, 20 amp.
• IN/OUT DMX & Channel Address
The Flickermaster DMX8©can be supplied as either a
120V or 220V model.
Please see page 2 for Remote and DMX
Instructions
SELECT
OFF -
Left hand knob in the OFF position, no output
from the Flickermaster DMX8©
DIM -
Set left knob to DIM when you wish to use
Flickermaster DMX8©as a dimmer, or when focusing
your lights so that they are not blinking or strobing.
Dimmer knob controls brightness and must be turned
up past zero for light to come on.
FLICKER -
Set left knob to this position when a
random flicker is wanted. (SPEED, LOW and DIM
are operational in FLICKER and STROBE mode.)
STROBE -
Set left knob to this position for STROBE effect.
SPEED
Use to adjust the rate of flicker or strobe - 0 is slow,
10 is the fastest. Speed setting is operational in
FLICKER or STROBE modes.
LOW LEVEL
Low level control allows for variable compression of the
flicker range to create the very low flickering of gas lamps
or a roaring fire. Functional when Flickermaster DMX8© is
set to FLICKER or STROBE modes.
DIM
Dimmer control - 0 being lowest, 10 the highest. Func-
tional in all settings except OFF. You may use the dimmer
to compress the high level of the flicker or to fade out an
effect in either FLICKER or STROBE modes.
For Best LED Results:
• Use 120 volt LED fixture or lamp that
does not require a transformer or power supply
For Best Fluorescent Results:
• If possible use dimmable ballasts for best results
• Excessive strobing or flickering may
shorten lamp life
