1. Using the base pole (H) as a template, mark
and drill three holes into the concrete
where you want to mount your lamp.
2. Using the concrete anchors, secure the
base pole (H) to the surface.
1.
Install the GS Solar LED Bulb into the Top (A).
2.
Locate the operation switch on the underside of the Top (A).
3.
Switch the lamp to either the Low or High setting according to your
preference:
Low = Softer light output and longer duration
High = Brighter light output
4.
The lamp will operate automatically at dusk.
Assembly Instructions
Operation Instructions
Replacement Batteries and Bulbs are available at
www.gamasonic.com or via our Toll Free number: +1-800-835-4113
Your Lamp can use the following bulbs:
A50WW10W – included bulb with Warm White LEDs (2700K)
A50BW10W – bulb with Bright White LEDs (6000K)
F30WW05W –Flame bulb with simulated flame LEDs
T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)
Your Lamp uses two of the following battery for each lamp head:
GS32V15
Replacement Parts
page 3
3. Attach the middle pole (G) to the base pole (H) using
the three provided screws.
4. Attach the top pole (F) to the middle pole (G) by
twisting it clockwise.
5. Attach the spacer pole (E) to the top pole (F) by
twisting clockwise.
6. Attach the finial (C) to the
centerpiece (D) by twisting
clockwise.
7. Attach the centerpiece (D) to the
spacer pole (E) by twisting
clockwise.
8. Attach the lamp head (A) to
the arm of the centerpiece
(D) by twisting clockwise.
9. Install the GS Solar LED Bulb and
switch the lamp to the Low or
High setting.
10. Install the fixture (B) to the
top (A) and secure using
the three screws.
11. Repeat steps 8-10 for the
second lamp head.
HIGH
LOW
