3
HOW TO OPERATE THE LANTERN FOR AUTO LIGHT UP FUNCTION:
1. Please plug the AC Adaptor into AC power supply (wall socket) then start for operation.
2. Push the ON/OFF switch (No.7) to "ON" position. The LEDs will light up immediately when AC power
fails. Push to “OFF” position to stop auto light up function.
HOW TO OPERATE THE UNIT
Push the ON/OFF switch (No.7) to "ON" position, the LEDs will light up immediately. Push to “OFF” position to
end the operation.
HOW TO RECHARGE THE UNIT
NOTE: Before recharging, please make sure the ON/OFF switch (No.7) must be in “OFF” position.
1. Plug the AC Adaptor to AC power source and connect DC plug into the unit.
2. The Charging Indicator (No.6) will light up indicating the lead-acid battery is under charging.
IMPORTANT NOTE
1. Please read the Instruction Manual carefully before operating the unit.
2. Make sure the electric rating of your home power supply before plugging into AC power source.
3. Keep recharging the lead-acid battery immediately after using the lantern.
4. Make sure the ON/OFF switch (No. 7) must be at “OFF” position when not in use.
5. The efficiency may decrease:
a. When the lead-acid battery is used to end without recharging.
b. When the lead-acid battery is charged at the temperature below 32ºF (0ºC) or above 104ºF
(40ºC).
6. Please keep out of reach of water or rain for proper use.
7. After charging, unplug the AC power cord from power source.
8. Keep recharging the lead-acid battery every three months if you are not using the lantern. Otherwise
the lead-acid battery may be damaged.
9. Switch off all functions when you are charging the lead-acid battery. Otherwise you will get lower
efficiency of charging.
10. During operation, when the light goes dim or the lead-acid battery turns into discharge protection,
charge the lead-acid battery immediately. Otherwise, the lead-acid battery may be damaged.
