Replacing the Batteries
Remove the top (C) from the fixture (D) by removing
the four screws.
Make sure the operation switch is in the Off position.
Remove the screw holding the battery compartment
door and remove the door.
Unclip the battery connectors and remove the batteries.
Make sure the new batteries are high quality Li-Ion
Batteries with matching connector (part# GS32V30).
Attach the new batteries and install them in the compartment.
Attach the compartment door and secure with the screw.
Turn the lamp back on by moving the operation switch to the
High or Low setting.
Secure the top (C) to the fixture using the four screws.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum performance. Do not
use any type of solvent for cleaning and be careful not to put too much pressure on the solar
panels while cleaning.
Troubleshooting
If your solar light does not come on as expected despite observance of all the instructions, please try
the following steps:
1. Make sure that the solar lamp is not being affected by any other light source.
2. Ensure the solar lamp is not positioned in the shade during the day.
3. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will last longer when it has
had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of the Li-Ion battery in the regular trash,
municipal waste stream or by fire as batteries may leak or explode. Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in
accordance with local, State and federal regulations. Do not mix old and new batteries.
page 4
Replacement Batteries and Bulbs are available at
www.gamasonic.com
Operation
switch