Parts Identification
& Manual Service
5/40
Issue 1.0
ATTENTION:
This equipment generates very high fluid pressure. High pressure spray can cause serious
injury. Read and understand all instructions before operating.
Never point the spray gun at anyone or at any part of the body. Never put hand, fingers over the
spray tip.
Always have the tip guard in place on the spray gun while spraying.
High pressure fluid in the hoses can be very dangerous. If the hose develops a leak, split or
rupture due to any kind of wear, damage or misuse, the high-pressure spray emitted from it can
cause a fluid injection injury or other serious bodily injury or properly damage.
Never use a damaged hose
Tighten all fluid connections securely before each use. High pressure fluid can dislodge a loose
coupling or allow high pressure spray to be emitted from the coupling.
Proper hose grounding continuity is essential to maintaining a grounded spray system.
If any fluid appears to penetrate your skin, get emergency medical care at once. Do not treat as
a simple cut. Tell the doctor exactly what fluid was injected.
All chemicals used in the pump must be compatible with the wetted parts of the pump.
PRESSURE HAZARD
This pump can develop 240 bar working pressure. Be sure that all spray equipment and
accessories used are rated to withstand this pressure. Do not exceed the maximum working
pressure of any component or accessory used in the system.
FIRE OR EXPLOSION HAZARD
Static electricity is created by the flow of fluid through the pump and hose. If every part of the
spray equipment is not properly grounded, sparking may occur and the system may become
hazardous. Sparking may also occur when plugging in or unplugging a power supply cord.
Sparks can ignite fumes from solvents and the fluid being sprayed, dust particles, whether you
are spraying indoors or outdoors, and can cause a fire or explosion.
If you experience any static sparking or even a slight shock while using the equipment, stop
spraying immediately. Check the system for proper grounding. Do not use the system again until
the problem has been identified and corrected.
GAS ENGINE (WHERE APPLICABLE)
Always place pump outside of structure in fresh air. Keep all solvents away from the engine
exhaust. Never fill fuel tank with a running or hot engine. Hot surface can ignite spilled fuel.
Always attach ground wire from pump unit to a grounded object, such as a metal water pipe.
Refer to engine owner’s manual for complete safety information.
PRESSURE RELIEVE PROCEDURE
To reduce the risk of serious bodily injury, including fluid injection, splashing fluid or solvent in
the eyes or on the skin, or injury from moving parts or electric shock, always follow this
procedure whenever you shut off the sprayer, when checking or servicing any part of the spray
system, when installing, cleaning or changing spray tips, and whenever you stop spraying:
