Parts Identification
& Manual Service
12/40
Issue 1.0
Star the engine or turn on the electric motor.
Increase the pressure by turning the pressure control knob slowly clockwise and test the spray
pattern on a piece of cardboard. Adjust the pressure control knob until the spray from the gun is
completely atomized.
NB
: Turning the pressure up higher then needed to atomize the paint will cause
premature tip wear and additional over spray.
PRESSURE RELIEVE PROCEDURE
WARNING!
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including servicing or adjusting
any part of the spray system, changing or cleaning spray tips, or
preparing for cleanup.
•
Lock the gun by turning the gun trigger lock to the locked position.
•
Turn off the unit
a) To turn off the gas engine
Set the pressure to minimum by turning the pressure control knob fully counter
clockwise.
Move the throttle lever to the slow position
Turn the engine switch to the OFF position.
b) To turn off the electric motor.
Set the pressure to minimum by turning the pressure control knob fully counter
clockwise.
Move the ON/OFF switch to the OFF position.
•
Close the hydraulic shut -off valve on the hydraulic pressure hose.
•
Unlock the gun by turning the gun trigger lock to the unlocked position.
•
Hold the metal part of the gun firmly to the side of a metal waste container to ground the
gun and avoid a build-up of static electricity.
•
Trigger the gun to remove any pressure that may still be in the hose.
•
Lock the gun by turning the gun trigger lock to the locked position.
•
Place the bleed hose into the metal waste container.
•
Open the bleed valve by turning it fully counter clockwise.