GAMATRONIC,
A
S
OLAR
E
DGE
D
IVISION
Centric Installation Guide, rel. 4.7
42
5.1
Insertion of power modules at system installation
When the installation instructions in section
3.2 call for it, do the following:
1.Verify the system controller is in place and is operating (CPU Active LED to the left of the LCD
screen is lit green), when the system is running. If the input breakers are off go to the next step.
2.Install the modules starting in the lowest available shelf and work your way upwards through the
available shelves.
For each module:
Push the module all the way into the module shelf. Push the module firmly to ensure proper seating
of the module’s rear connectors. Fasten the module to the UPS frame with two screws type M5
conical, one on the left and one on the right of the module face.
