G
AMATRONIC
E
LECTRONIC
I
NDUSTRIES
L
TD
.
CENTRIC User Guide, rel. 3.4
39
3.
To delete a community, first touch the community name to be deleted. In the screen that appears
(similar to Figure 26), click
DELETE
at the bottom of the screen.
7.2.6.2.2
SNMP
CONFIGURATION
>
ACCEPT
SNMP
PACKETS
FROM
THESE
HOSTS
Selecting this check box allows SNMP packets to be accepted from any host. You also have the option of
adding hosts (see Figure 27). Adding or deleting hosts is performed in the same manner as adding or
deleting communities—see section
7.2.6.2.1.
7.2.6.2.3
SNMP
CONFIGURATION
>
TRAP
DESTINATIONS
An SNMP trap is a destination to which the
Centric
will send alarm notifications using the SNMP protocol.
For each destination, an IP address and a port must be specified.
Adding or deleting trap destinations is performed in the same manner as adding or deleting communities—
see section
7.2.6.2.1.
Note
:
Centric
supports the UPS MIB (Management Information Base) standard.
7.2.6.3
SERIAL COMMUNICATION (OPTIONAL FEATURE)
Serial communication is an optional feature, available by special order.
This option enables serial communication between the
Centric
and an external device. Indicate the port to
be used and the baud rate. Choose one of the ports from the list.
If your system includes this option, the serial communication connector is labeled "RS232" and is located
on the left side of the static switch on the rear side of the UPS.
Figure 28: Defining serial communication parameters
Note: If the serial communication option is ordered as an add-on to an existing system, the physical
connection details may be other than described above.
