G
AMATRONIC
E
LECTRONIC
I
NDUSTRIES
L
TD
.
MegaV2 250 Installation Guide, Release 2.2
47
3.
On the right side of the computer is another metal panel. Remove it, and carefully
disconnect all the cables from the right side of the computer.
4.
Remove the two screws from the front of the computer. See Figure 51.
Figure 51: Two screws on the front of the computer
5.
Slide the old computer box out of the
MegaV2 250
.
6.
Slide the new computer into the
MegaV2 250
and connect the wires on the right side of the
computer.
7.
On the left side of the computer, connect the rightmost flat cable (see Figure 50).
8.
Connect the remaining flat cables to the computer and then insert and tighten the two
screws on the front of the computer.
9.
Connect the power cable on the left side of the computer. If the computer doesn't power-up
by itself, press the "Reset CPU" button on the front panel to power it up.
10.
Refasten the metal panels on both sides of the computer.
