Gamatronic Electronic Industries Ltd.
Power+ Technical Guide
49
4.3
INITIAL START-UP SEQUENCE
Note: Before first setting up the UPS, make sure that the load is not connected.
1.
Ensure that the maintenance bypass switch (if installed) is disconnected.
2.
Turn the AC input and AC bypass switch ON and wait (for about 2 minutes) for the
POWER+
to initialize.
When applying power to the
POWER+
, the system automatically runs the startup process
without a need to press the On/Off button.
The start-up sequence will begin and the control panel will show the following sequence.
(The details will vary, depending on your application.)
During this step, the LEDs are also checked sequentially.
Power up
Start-up 1
Figure
4-3: Start-up screen 1
Power up
Start-up 2
Figure
4-4: Start-up screen 2
Power up
Start-up 3
Figure
4-5: Start-up screen 3
Power up
Start-up 4
Figure
4-6: Start-up screen 4
