Gamatronic Electronic Industries Ltd.
POWER+ RM100,
3
X
208
V, User Guide, 1.3
137
11.
T
HE
P
OWER
+
BUILT
-
IN
W
EB INTERFACE
The Power+ built-in Web interface enables you to monitor and control the Power+ from a distance, using a
PC over an Ethernet network. All that is required is an HTML browser such as Microsoft’s Internet Explorer.
11.1
Preliminaries to use of the Web interface
To enable the Power+ Web interface:
1.
Consult with your Network Administrator to obtain an IP address for your Power+, and the appropriate
mask and gateway address.
2.
Configure the Power+ with the IP address. This is done from the Power+ main menu as follows:
a.
Setup >
(enter your password, then press
Ent
; default password is 8 left arrows)
>
Service > SC2012 > Network.
b.
From the Network menu, choose
IP Address
and enter the assigned IP address.
c.
From the Network menu, choose
Gateway
and enter the assigned Gateway address.
d.
From the Network menu, choose
Mask
and set the assigned subnet mask.
e.
From the Network menu, choose
Store
to save the information just entered.
3.
Connect the Power+ to the local Ethernet network using the Ethernet (RJ45) port on the rear panel of
the Power+ controller. This is the port labeled “TCP/IP Port” on the left side of the controller rear
panel in Figure 291 below.
Figure 291: Power+ controller rear panel
4.
On a computer terminal that has connectivity to the Power+ IP address, open a Web browser and
enter the Power+ IP address in the URL bar. For example, type
//154.102.2.130
and press Enter. You
should see the Web interface main screen (see Figure 292 below).
