Gamatronic Electronic Industries Ltd.
POWER+ RM100,
3
X
208
V, User Guide, 1.3
157
14.
W
ING
:
W
IRELESS
C
ONTROL
(
OPTION
)
The
POWER+
system includes an option for wireless control and management, using Gamatronic's
Wing
.
The
Wing
allows real-time detection of power system faults and immediately notifies selected recipients
(control center, technician, etc.) detailing the faults.
The
Wing
consists of:
Wing board.
SIM board.
Antenna.
D9-D9 cable (for RS232 between the Power+ and the Wing).
Dc power cable (banana plugs on both ends).
Figure 311:
A Wing unit connected to the PowerPlus
14.1
Installing the Wing
Note: The instructions in this section are for a Wing unit that has been ordered
specifically for use with a Power+ system.
If your Wing was ordered for use with another
type of system, it does not contain the appropriate software for use with a Power+ system and
you should contact your Gamatronic representative if you wish to convert it for Power+ use.
To install a Wing unit for use with a Power+ system:
1.
Take the Wing and press the button on the left side of the SIM slot to unlock the SIM cardholder;
remove the SIM cardholder from the Wing.
2.
Place your SIM card (which you obtained from your cellular service provider) in the SIM cardholder
and slide the SIM cardholder gently and firmly back into the Wing.
3.
Attach the supplied cellular antenna to the Wing.
4.
Connect the Wing to the D9 socket labeled "Wing" on the left rear side of the controller using the
supplied D9-D9 cable.
