3.6 SERVICE (sub Menu)
1.
On the System Setting Menu, select item “
6. Service
” and press
1P-START
to
enter the Service Menu.
Figure 4 ::
Service Menu
NOTE:: The Dark Blue text is very difficult to read
2.
Moving 1P joystick up or down to choose item, then
1P-C
to modify item.
3.
SW1
switch on game board adjust Display Mode. See Remark para 3.6.1..
4.
After finishing modification, press
1P-START to save
setting(as figure 5), then
press
1P-A to return System Menu
.
5.
Select "
1. Exit
" to exit, the new configuration is valid after system automatically
restarts.
Figure 5::
Saving Text
3.6.1 Display Mode (Setting Switch SW1)
1.
Display mode
This game board support both VGA and CGA display modes, see below for
settings.
VGA mode
(31.5Khz): Before switching on the machine power, set BIT1 of SW1
ON. Connect the VGA monitor to the VGA output connector. The output resolution
is 800x600.
CGA mode (15.75KHz):
Before switching on the machine power, set BIT1 of SW1
OFF to use a regular JAMMA cabinet.
The VGA port output is invalid.
Remark: Do not operate SW1 with power applied. This may cause the special
electronic smoke to leak out affecting normal operation!
Summary of Contents for 412 in 1
Page 1: ...ELF 412 in 1 Arcade Game Board Manual ...
Page 7: ...4 ...