Instruction Manual : 6’ X 6’ HYBRID BLIND
16
STEP 3
FIGURE 3
FIGURE 4
STEP 4
3. Attach the four middle hubs (2) to the (18) poles so
that the snap buttons secure the parts together. SEE
FIGURE 3.
Attach the two (30) parts to the middle hubs (2)
and the (15) and (17) poles as shown. The end that
attaches to the middle hub does not attach with
a snap button and will be secured together with
hardware in a later step. SEE FIGURE 3.
Slide each (24) pole into the corresponding (23)
pole so that the snap button secures both parts
together. SEE FIGURE 3.
Slide the three assembled (23, 24) poles into the
four middle hubs (2). These do not attach with snap
buttons and will be secured together with hardware
in a later step. You should now have the middle tier
frame of the blind assembled. SEE FIGURE 3.
4. Attach each of the eight (22) poles to the bottom
and middle tiers of the blind frame using two 1/4-
20 X 1-1/2 IN bolts (49) and 1/4-20 nuts (56). SEE
FIGURE 4.
Pay attention to the orientation of the
bolts! The head of the bolt must be on the outside of
the frame. This helps prevent wear on the skin when
fully assembled.
18
2
17
15
30
23
24
56
49
22
23
24
23
24
56
49
