IF 610 Installation and Operation Manual
Issue 3, 10/04/00
Firmware Ver. 7
101
ASCII Upload
To Down Load
1) Echo locally
No
1) Press PgUp
2) Expand blank
lines ....
Yes
2) Choose 7
(ASCII)
3) Pace Character
0
3) Enter “Dict”
(filename)
4) Character Pacing
15
5) Line pacing `
10
CR translation
none
6) CR translation
none
LF translation
none
7) LF translation
strip
Change Card
IMPORTANT: THE ONLY CARD THAT CAN BE CHANGED IN THE IF 610 IS
CARD #17 IN ORDER TO CHANGE THE NUMBER OF CIRCUITS.
The IF 610 system allow components to be added or deleted without disturbing the
programming (Control By Event, etc.) of other system components. When the Change
Card menu is selected, an Add or Delete option is then prompted. Select the desired option
and enter the card number to be changed. (See system configuration in the installation
section of this manual for card location information)
NOTE: When changing card types in a location, the existing card should be deleted
before the new card is added. This will ensure that the control by event table is up to
date.
Change Menu 4
1=Cfg 2=Water 3=Relse 4=Dump
5=Dict 6=Card 0=Exit
>6
Change Card Menu
1=Add 2=Delete 0=Exit
>1
Enter Card # To Add:
Delete Existing Card First !
Press Enter Key To Continue
Change Card Menu
1=Add 2=Delete 0=Exit
>2
Enter Card # To Delete: 1
Card Deleted From System
Press Enter Key To Continue
Change Card Menu
1=Add 2=Delete 0=Exit
Enter Card # To Add: 1
Card Added To System
Press Enter Key To Continue
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com
