IF 610 Installation and Operation Manual
Issue 3, 10/04/00
Firmware Ver. 7
44
ByPass Group Programming
1. Select [4] from the ByPass Menu. Figure T11 is now displayed
ByPass Group Programming
1=Assign Devices to ByPass Group
2=Activate/Deactivate ByPass Groups
0=Exit
Figure T11
2. Select [
1
] from the menu to assign Devices to ByPass groups, then select
either [
1
} for Inputs, or [
2
] for Outputs
3. Select the desired Circuit and Device by using the arrow keys. With the
left/right arrow keys select
B_Grp:
. Using the up/down arrow keys select the
desired ByPass Group number, or enter the number and press the ENTER
key.
4. Repeat this process until all of the desired Devices are assigned to ByPass
Groups.
5. Press the Enter key to exit the menu to active or deactivate ByPass Groups,
press[
2
] at the ByPass Group Programming menu
7. Enter the number of the desired ByPass group and press the Enter key
8. The selected ByPass group number will be displayed with a message that the
Group is either ByPassed or NOT ByPassed.
9. Pressing any key will toggle the state of the group. When the desired
condition is shown, press the Enter key to go to the next group selection.
10. Pressing the Enter key at the Group number selection screen without entering
a group number will exit the ByPass Group Activate/Deactivate programming
operation.
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com
