IdentiFlex 630 Installation and Operation Manual
S
mart
S
tart Capable
9-25-96
54
5.
Use the right arrow key to move to "Z_Type:". Use the up/down arrow keys to
select zone type. Only zone types that apply to device types will be displayed.
Refer to Table P2 - page 52 - for a complete list of all zone types.
Initiating Group Selection
6.
Use the right arrow key to move to "I_Grp". Enter the initiating group number
or use the up/down arrow keys to select initiating group type (see Field
Description).
User Text Selection
7.
Use the right/left arrow keys to move to select
text word dictionaries
"W1”
through “W5:" field (not shown until selected).
8.
Use the up/down arrow keys or enter the three digit word number to select text
entries from
text word dictionaries
"W1” through “W5:". The ## represents the
text entry number in dictionary
D.
See Figure 10.
Û
NOTE: The "WD" field is not displayed until the cursor is
placed in its field. When the dictionary 1 through 5 is selected
"WD" will be shown on the lower right hand corner of the
display. See Figure 10.
Ckt:XX Add:xxx D_Type:xxx Z_Type: xxx
I
_Grp:x
WD:###
xxxxxx xxxxxxx xxxxxxxxx
xxxxxxxxxxx xxxxxxxxxxx
Figure 10
9.
When the desired coded word is displayed, use the left/right arrow keys to select the next field.
Û
NOTE: It is not necessary to press "Enter" when the Up/Down arrow keys are used to change the
parameter of a field. The field contents are automatically updated for the device as shown on the
display (Except I_Grp).
10. When all input devices have been programmed, press "
Enter
" to exit the input circuit programming
mode.
____________________________________________________________________________________________
Summary of Contents for Smart Start IDENTIFLEX 630
