22
Mounting instructions / FK 2, FK4, FK6, FK 8
Required tools:
Screw wrench M10
Screw driver
Socket-head screw wrench 6 mm
1. Place the base on the flat side. In case of great unevenness you can
place adjustable feet in the prepunched holes.
2. Mount the back panel on the base and secure the cupplings by means
of socket-head screw wrench 6 mm.
3. Mount the side panels by means of socket-head screw wrench 6 mm.
Attention: The plastic strips have to be on the frontside.
4. The sidepanels have to be flat with the base panel.
5. Place the top panel on the black panel and the side panels and mount
by means of socket-head screw wrench 6 mm.
6. Place the hinge pins in the bottom of the top panel.
7/8 Place the left an right door panels into upper hinge pins.
9. Adjust lower hinges, plug in the hinge pins from under and secure by
means of screw wrench (M10).
10. Place the middle post and adjust it.
11. Place the cooling machine on the hollow of the top panel.
The condenser is visible on the front so cleaning is easy.
After installation, leave the Keg Cooler standing for at least 24 hours
before switching on to avoid damaging the compressor.
Summary of Contents for FK
Page 2: ...2 Nederlands 4 Deutsch 9 English 22 Fran ais 27...
Page 3: ...3...
