-
HYDROLOUNGE PEDICURE CHAIR User’s Manual –
GAMMA & BROSS spa - Via Mazzini,62/E- 46043 CASTIGLIONE DELLE STIVIERE (MN)
12
-
Check water pressure: it is advisable to use the pedicure spa at a 3-Bar pressure. Install, if necessary,
a pressure reducer.
-
Check that a supply hot water adjusting thermostat is installed: it must not be over 66°.
-
It is necessary to fit ball valves in the supply pipes to facilitate maintenance.
WARNING: Before connecting the faucets, purge the water
system to avoid that sand and residual dirtiness obstruct the
faucets and damage the sophisticated faucet ceramics.
3.5 HYDROLOUNGE PEDICURE CHAIR MOUNTING
1) Lift the
HYDROLOUNGE PEDICURE CHAIR
, remove the packaging with extreme care and position the
arcmchair in the place in which it is intended to be used.
2) Remove the front & rear steel covers by undoing the self-tapping screws. (start with the front one)
It is forbidden to connect the electric equipment directly to the cables of the
power supply system of the room: faults in the power supply system may
irreparably damage the
HYDROLOUNGE PEDICURE CHAIR and cause
serious accidents to those in contact with the pedicure spa.
