- 5 -
0 1 0 I 0 1 I I
-digit
decimal
0.0
0 1 0 I I 0 0 2-digit
decimal 0.00
0 1 0 1 1 0 1 3-digit
decimal 0.000
0 1 0 1 1 1 0 4-digit
decimal
0.0000
State B: Unit and weighing mode control character (D7 refers to verification bit)
D7 Verification bit
D6 0
D5 1
D4 1
D3 Dynamic mark bit
D3--0, stability;
D3=1, non-stability (dynamic)
D2 Overload mark bit
D2--O, normality; D2=1, overload
D1 Positive and negative mark bit DIA, positive number: D1=1, negative number
DO, Gross weight and net weight mark bit DOA, gross weight; D0=1, net weight
State C: Blank space
5. Use Guide
5.1 Do not use under the environment of heavy dusty and high vibration.
5.2 Place the article in the center of the platter as far as possible.
5.3 Never use high corrosive solvents to clean it.
5.4 Do not weigh overload, weight (tare included) can't exceed its Max. Capacity
plus 9d ("d" is division value). If the weight exceeds this value, the indicator will
display as "FULL", and may possibly give out beep sound.
5.5 Do not place article on platter for a long period of time and never bump platter
in a sudden, otherwise, the load cell may be damaged.
5.6 Be sure that charging rechargeable battery in time if your scale has one.
5.7 Don't disassemble it without authorization.
5.8 If the display doesn't change during operation, turn off the switch of battery and
pull out the adaptor plug, then turn on the scale again.
5.9 If something is wrong, immediately turn off the switch of battery (or storage
battery) and pull out the adaptor plug. Non-professional staff can't fix it without
authorization. Contact our sales agent in local area.
5.10 To recalibrate the scale, do it after warmed up for 30minutes.
6. Battery Maintenance
If using the rechargeable battery, please recharge it more often. Otherwise work
with attached adaptor.
<END>
