15
TROUBLESHOOTING TIPS
PROBLEM
SOLUTION
String slips in clamps
String slips in string gripper
String clamp Lock knob is difficult to turn
String tension too tight or too loose
To check fuse, remove the power cord and pull the fuse holder straight out. Remove the
fuse from the clips and examine it. If it is burned out, replace it with the spare fuse and
replace the fuse holder in its socket. Supply power to the machine and check for proper
operation. If problems persist, contact Gamma Sports Customer Service at 1-800-333-
0337
•
Adjust gap between jaws
•
Clean clamp jaws
•
Clean gripper jaws
•
Make sure string is wrapped over
upper gripper jaw before inserting
between gripper jaw plates
String clamp slips on base
•
Clean base of clamp and top of
turntable
•
Check for proper position of thrust
bearing in the base of the winged lock
knob
•
Check tension using a tension
calibrator and adjust machine
calibration if necessary
With time and use, the clamping surfaces of your machine may become oily or dirty and result
in string or clamp slippage while stringing. Periodic cleaning of the following parts is
recommended.
String Clamps
Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner
soaked with isopropyl alcohol between the jaws and rub back and forth. If the build-up is
excessive, dismantle the string clamp jaws to expose the gripping surfaces by removing the
adjustment screw. Using a small nylon brush, (such as a toothbrush), scrub the inside
surfaces until all debris is removed. Clean the jaws with isopropyl alcohol and re-assemble.
String Clamp Base
Clean the base of the clamps and the top of the turntable with isopropyl alcohol.
String Gripper
Clean inner gripping surfaces with isopropyl acohol soaked cloth or pipe cleaner.
CARE and CLEANING
Electrical system does not function
•
Check power source
•
Check power cord connection
•
Check fuse
•
Call Gamma Sports customer service
