Safety Clamp
Safety Cable
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Do not clamp the safety cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the led profile spotlight if the
clamp fails.
Then the safety cable would be the backup and stop the fixture from falling to the ground. So
do NOT fix the safety cable to the same place that the C-Clamp is attached
Never stand directly below the device when mounting, removing, or servicing the fixture.
From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept
at least 0.5m (1.5ft) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental
damage and/or injury in the event the clamp fails.
∙Don’t try to modify the fixture without any instruction by the manufacturer or the appointed re-
pairing agencies.
∙Warranty is voided if there are any malfunctions from not following the user manual while op-
erating or any hazardous operation, like shock short circuit, electronic shock, lamp broken,
etc.
Luxé Toro 600 RGBAL– GAMMA LED Vision
Page 4 of 14
