3-Pin to 5-Pin Conversion Chart:
Note!
If you use a controller with a 5 pin DMX output connector,you will need to use a 5 pin to 3
pin adapter. The chart below details a proper cable conversion:
3-Pin to 5-Pin Conversion
Conductor
3 Pin Female(Output)
5 Pin Male(Input)
Ground/Shield
Pin 1
Pin 1
Data(-) signal
Pin 2
Pin 2
Data(+) signal
Pin 3
Pin 3
Not Used
Do not use
Not Used
Do not use
Setting up a DMX Serial Data Link:
Master/Slave Fixture Linking:
1.
Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture.
2.
Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output as stated above to the input of the following fixture
and so on.
4. DMX Channels Summary
Led Par Light
4.1 Operation method
1.
keystrokes
2.
Basic usage
