6
Clamp Head Installation
The post of the string clamp head and tube of
the string clamp base are treated with grease
to provide protection against corrosion during
shipping. Remove any excessive grease with
a clean cloth prior to use. The post and tube
may also be cleaned with isopropyl alcohol.
After this type of thorough cleaning, the post
and tube should be treated with a light coating
of machine oil to protect the surfaces against
corrosion and to ensure smooth operation.
ASSEMBLY INSTRUCTIONS
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the screw
and washer into the end of the tensioner bar.
Note:
The tensioner bar is equipped with
a tensioner travel stop to limit travel of the
tensioner along the bar. See page 10 for
more details about this feature.
Support Post Installation (cont’d)
Place the support post onto the central slot
of the turntable. With your fi ngers placed
through the large hole in the underside of the
turntable, press the mounting plate against
the inside top surface of the turntable while
aligning the hole in the support post with the
hole in the mounting plate and fi x them with
the mounting bolt. Repeat procedure on to
attach the support post on the opposite side
of the turntable.
