10
D 3i
To enable this function, you must do two things:
First of all: Press the little switch labeled Bypass
downwards, it is located at the back of the D 3i
just beside the CD input.
Secondly:
While the CD input source has been chosen,
you press the push knob just below the display
Bypass.
Now the dot below CD will move below Bypass
and the signal goes directly into the power
ampli
fi
er. Please note that the volume control
of the D 3i is no longer in use and if you are not
very careful you might experience a full level
output!
When the Bypass function has been enabled the
source selecting route is changed. Instead of
selecting CD input the Bypass dot will light. See
illustration:
Connecting to a surround Processor
HTH Direct function is intended for cases where
the D 3i is connected to a surround preampli
fi
er
or processor. Enable the Direct function by push-
ing the small switch situated at the left side of
the HTH input terminals on the backside of the
preampli
fi
er.
The Direct function of this input will bypass the
volume control and lead the signal directly to
the output of the D 3i. This converts the D 3i
into a non-amplifying and non-level adjusting
device. Leading the two front channels of a sur-
round system directly into your power ampli
fi
er.
Please note:
While the HTH Direct is enabled
and the HTH input is selected, the volume
control volume will be disabled to avoid con
fl
ict
with other remote control systems.
