Basic configuration of the KVM-over-IP™ connection
G&D ControlCenter-IP-XS ·
17
English
4. In the menu, click on
Matrix systems > [Name] > Console modules
or on
Matrix systems > [Name] > Target modules
5. Select the end device to be unpaired.
6. Click on
Unpair device
.
Determination of the type of video transmission
In the default setting, the target modules (
IP-CPU
) send the video streams via multi-
cast to the user modules (
IP-CON
).
This option allows users with »Target multi access« right to connect to a computer
to which
another
user is already connected.
Alternatively, you can specify that the target modules (
IP-CPU
) send the video
streams via
unicast
to the user modules (
IP-CON
).
The connection of a user to a computer to which another user is already connected
is
not
possible in this mode (message:
No multicast video
)!
You can define the type of video transmission system-wide. The system-wide setting
is applied by default by all target modules. In addition, you can specify the type of
video transmission individually for each target module.
How to configure the system-wide multicast or unicast video transmission
setting:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press
F11
to call the
Configuration
menu.
3. Select the
System
entry and press
Enter
.
ADVICE:
Multiple selection of devices is possible.
IMPORTANT:
The multicast streams are controlled by the network switches and
enable efficient distribution of the streams to multiple recipients at the same time.
Please note the requirements for the
network switch
for sending the video streams
via multicast. Refer to the Installation Guide for detailed information.
NOTE:
This option places significantly
less
demands on the network switch.
Summary of Contents for ControlCenter-IP-XS
