Use of the Reset button
G&D DL-DVI-MUX2-NT ·
14
English
Use of the Reset button
The
Reset
button is placed on the front of the device (between the
Identification
LED
and the
Status
LEDs).
You can use the button to restore the default settings or to temporarily disable the
network filter rules.
Restoring the default settings
Pressing and holding the button during booting restores the default settings of the
KVM switch.
How to restore the system defaults:
1. Switch the device off if it is in use.
2. Press and hold the
Reset
button on the front panel of the device.
3. Keep the button pressed and switch the device on.
4. Release the button as soon as the green
System
LED starts blinking fast.
NOTE:
To avoid pressing the button by accident, it is placed behind a hole in the
front panel.
Use a thin, pointed object to press the button.
NOTE:
After this, the default settings of the KVM switch apply again.
NOTE:
You can also use the OSD or the web application
Config Panel
to reset the
default settings.
