User module »DP-HR-U-CON-Fiber-MC2«
127
· Target and user modules (DP-HR-U)
Enable the
Generic HID
mode (see page 175 f.) if you want to connect another USB
input device. In this mode, data of the USB input device remains unaltered when
transmitted to the active target module.
USB Devices:
Connect any USB devices to these interfaces. The data stream of the
connected USB device is transmitted to a compatible target module with up to 16
Mbit/s.
LED Out:
If you purchased and added the
TradeSwitch feature
to the matrix switch,
connect the optional
TS-LED
2 here (order number A6100041).
Connection to the matrix switch
Transmission 1|Tx:
Insert the LC plug of a compatible optical fibre cable. Connect the
other end of the cable to the
Rx
interface of a
Dynamic Port
provided at the matrix
switch.
Transmission 1|Rx:
Insert the LC plug of a compatible optical fibre cable. Connect the
other end of the cable to the
Tx
interface of the same
Dynamic Port
provided at the
matrix switch.
IMPORTANT:
With enabled
Generic HID
mode, it is
not
possible to operate the OSD
with a keyboard connected to the
Generic
socket.
IMPORTANT:
The devices use components with laser technology which comply
with laser class 1.
They meet the requirements in accordance to
EN 60825-1:2014
as well as
U.S. CFR 1040.10
and
1040.11
.
Mind the following instructions when dealing with laser beams:
Avoid direct eye exposure to beam
Always connect optical connections or cover them with protection caps
Only use G&D certified transmission modules
NOTE:
Use optical fibres with LC plugs to connect the devices. The cables are
available as accessories.
Transmission 2
Transmission 1
Micro In
Speaker
Keyb./Mouse
Generic
Main P
ower
Red. Power
Mouse
Keyb.
LED Out
DisplayPort Out 1
DisplayPort Out 2
USB Devices
Summary of Contents for DP-HR-U
Page 1: ...A9200141 1 30 G D Target and User Modules Installation and Operation DP HR U variants EN ...
Page 194: ... ...
Page 195: ... ...
