Target module »DP-HR-U-CPU-Fiber-DH«
Target and user modules (DP-HR-U) ·
66
Target module
»DP-HR-U-CPU-Fiber-DH«
With the
DP-HR-U-CPU-Fiber-DH
target module you can connect a computer with up to
two
DisplayPort
graphics outputs (dual monitor) to a digital matrix switch of the
ControlCenter-Compact
or
ControlCenter-Digital
series by using one cable only.
Users at the consoles of the matrix switch can access the target module and operate
the connected computer.
The data stream of the USB devices connected to the active user module (
DVI-U-CON
,
DP-U-CON
and
DP-HR-U-CON
series only) is transmitted to the computer with up to 16
Mbit/s.
Package contents
1 × Target module
DP-HR-U-CPU-Fiber-DH
2 × DisplayPort video cable (
DP-Cable-M/M-2
)
1 × USB device cable
2 × Audio cable
1 × Power pack (12V/2A, only with variants incl. PowerPack)
1 × Power cable (only with variants incl. PowerPack)
1 × EasyStart flyer
1 × »Safety instructions« flyer
Required accessories
1 × Compatible optical fibre cable to connect the target module to
the matrix switch
NOTE:
This target module can be connected to a compatible fiber port of
ControlCenter-Compact
matrix switches or
ControlCenter-Digital
matrix switches
(requires
CCD-I/O 16-Card-Fiber
).
IMPORTANT:
Both, the target module and the fiber ports are available as
single-
mode
variants or as
multi-mode
variants. Make sure that the port at the target mod-
ule, thefiber port and the optical fibers are compatible with each other.
ADVICE:
If you use the first video channel only, you are able to display resolutions
up to 4096 × 2160 @ 30 Hz (4K). Using both video channels allows resolutions up
to 1920 × 1200 @ 60 Hz. Detailed information about the supported resolutions is
given in the chapter
IMPORTANT:
At consoles with one monitor only, the image of the computer’s sec-
ond video output is not displayed.
Summary of Contents for DP-HR-U
Page 1: ...A9200141 1 30 G D Target and User Modules Installation and Operation DP HR U variants EN ...
Page 194: ... ...
Page 195: ... ...
