Initiation
G&D DVIMUX4-DL-USB ·
8
Initiation
Turn on the
Power
switch on the back panel of the KVM switch.
As soon as the device is supplied with power, the green
User
LED lights up. The
KVM switch is now ready for operation.
Status displays
The LEDs on the front panel of the device enable you to control the operational status
at all time.
Section
LED
Status
Meaning
CPU 1 ... 4
Active
on
The KVM switch is currently active on this channel.
All inputs are forwarded to this computer.
All connected USB devices are provided to the active
computer.
off
The channel is currently inactive.
Status
on
The computer is ready for operation.
off
No computer is connected or the computer is turned off.
User
Active
on
The keyboard was fully and properly initialised.
slowly
blinking
The LED is blinking after the device has been turned on
and until the keyboard has been initialised
blinking
The setup mode of the KVM switch is active.
Status
on
The KVM switch is supplied with the necessary voltage.
off
The KVM switch is turned off or is not supplied with the
necessary voltage.
If necessary, check if the power cable has been properly
connected.
