Configuration
84
· G&D VisionXS-F-DP-UHR
Information display
Information displays are shown temporarily (5 seconds) in the upper left corner.
The information display can also be shown permanently or it can be disabled.
How to change the setting of the information display:
Adjusting the transparency of the OSD
In the
default
settings of the KVM switch, the OSD covers parts of the screen con-
tent. However, the parts of the screen contents covered by the OSD are still visible.
You can adjust the transparency level or turn the transparency off.
How to adjust the transparency of the OSD:
OSD
1. Press
Ctrl+Num
(
default
) to open the OSD.
2. Press
F10
to open the
Personal Profile
menu.
3. Under
Display
press
F8
to select between the following options:
off
information display is turned off
temp
information display is shown temporarily for 5 seconds (
default
)
permt
permanent information display
4. Press
F2
to save your settings.
OSD
1. Press
Ctrl+Num
(
default
) to open the OSD.
2. Press
F10
to open the
Personal Profile
menu.
3. Under
OSD transparency
press
F8
to select one of the following options:
high
high transparency of the screen content
average
average transparency of the screen content (
default
)
low
low transparency of the screen content
off
screen content is covered
4. Press
F2
to save your settings.
Summary of Contents for VisionXS-F-DP-UHR
