Configuration
G&D VisionXS-F-DP-UHR ·
85
English
Automatic closing of the OSD after inactivity
If desired, you can set the OSD to close automatically after a period of inactivity.
The period of inactivity can be defined by entering a value between
5
and
99
seconds.
How to change the period of inactivity after which the OSD closes:
Changing the position of the information dispaly
In the
default
configuration, the information display is shown at the left upper corner
of the console monitor. However, you can adjust the position to your liking.
How to change the position of the information display:
NOTE:
To disable the function, enter the value
0
.
OSD
1. Press
Ctrl+Num
(
default
) to open the OSD.
2. Press
F10
to open the
Personal Profile
menu.
3. Select the row
Close OSD when inactive for [s]
and press
Enter
.
4. Enter the desired time range from
5
to
99
seconds and press
Enter
.
5. Press
F2
to save your settings.
OSD
1. Press
Ctrl+Num
(
default
) to open the OSD.
2. Press
F10
to open the
Personal Profile
menu.
3. Select the row
Set display position
and press
Enter
.
The message on the right is shown at the current
position of the information display.
4. Use the
arrow keys
or the mouse to move the
menu to the desired position or press
Ctrl+D
to reset the
default
position..
5. Press
F2
to save your settings or
Esc
to cancel the process.
+
Display position
F2: Save
Summary of Contents for VisionXS-F-DP-UHR
