Installation
9
· G&D VisionXS-IP-F-DP-UHR
Connecting audio and RS232 interfaces (depending on model)
Line In:
Use an
Audio-M/M-2
audio connection cable to connect the omputer’s
Line-
Out
interface to this interface
Serial:
Use the
RS232-M/F-2
cable to connect one of the computer’s 9-pin serial inter-
faces to this interface.
Establishing a connection to the Gigabit Ethernet
Transmission 1|Tx:
Insert the LC plug of a fibre optic cable, which is available as
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
Transmission 1|Rx:
Insert the LC plug of a fibre optic cable, which is available as
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
NOTE:
By default, the KVM switch transfers audio data between switches.
In addition, you can enable the transmission of RS232 data and, alternatively,
disable the transmission of audio data (see
IMPORTANT:
The devices use components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE:
Remove the protection caps from the
Transmission
interfaces and from the
cable plug.
NOTE:
The activation of the
Transm. Redundancy
feature activates the
Transmission 2
interface.
Use this interface to establish a redundant
transmission
connection (
link aggregation
)
with the Gigabit network.
Line In
Serial
USB CPU
DP CPU
USB CPU
DP CPU
Transmission 1
Service
Pwr Main Power
Transmission 2
Red. Power
Network
Service
Pwr Main Power
Transmission 2
Red. Power
Network
Summary of Contents for VisionXS-IP-F-DP-UHR
