Start-up
G&D VisionXS-IP-F-DP-UHR ·
14
English
Start-up
After the proper installation of the KVM extenders they can be immediately put into
operation.
Mind the following activation sequence when starting the modules:
1. Switch on the external power supply of the
user module
or
switch on the internal power supply (desktop variant only).
2. Switch on the external power supply of the
computer module
or
switch on the internal power supply (desktop variant only).
3. Turn on the
computer
that is connected to the computer module.
Starting process
After the computer module and the user module are turned on, the LEDs on the
back panel show the module’s operating status.
For further information about this topic, also see the chapter
On-screen display of the user module
When starting the user module, information about the starting process as well as the
firmware versions and IDs of the connected modules are displayed in the monitor of
the user module.
Additionally, the
local hotkey
(default:
Alt
+
Num
) to open the local OSD of the user
module and the remote OSD
remote hotkey
(default:
Ctrl
+
Num
) to open the remote
OSD of the computer module are shown.
NOTE:
The recommended activation sequence ensures that the KVM extenders
are able to read out the features of the connected monitor and to transmit them to
the computer (see
DDC transmission with cache function
ADVICE:
Press
Pause
to stop the process. Pressing
Space
continues the process.
Summary of Contents for VisionXS-IP-F-DP-UHR
