ABOUT THE INSTRUCTION
1
PURPOSE OF
INSTRUCTION
The instructions are intended for the operator of the equipment and all persons
who come into contact with it.
contact during
installation
,
operation and maintenance
.
PLATINUM
INSTRUCTIONS
These instructions are valid for all supplied types of CYGG cyclone separators
SYMBOLS USED
INSTRUCTIONS
SYMBOL
IMPORTANCE
These symbols have the meaning of "
WARNING
" and "
CAUTION
"
and indicate facts that may cause serious injury to the user and/or
damage to the equipment. They also draw attention to an important
instruction, feature, procedure or matter that must be followed
during
operation and maintenance of the equipment to comply with or take note of.
The symbol draws attention to an important action that must be
followed but which does not endanger health or cause damage to the
product.
The symbol highlights useful information related to the device
or its accessories.
The symbol is a reference to another chapter in this manual.
Caution for cyclone installed in hazardous a r e a s .
IMPORTANT
NOTICES
Please read these instructions carefully. Follow the instructions in this manual to
ensure not only ease of use, but also optimum use and longevity of the equipment.
Do not operate the equipment until you are thoroughly familiar with all the
instructions, prohibitions and recommendations contained in this manual.
The illustrations used in this manual do not necessarily correspond to reality; they
are intended to describe the main principles of the device. However, the texts,
drawings, photographs and other elements shown here are protected by
copyright. Any misuse or unauthorized copying is punishable.
The instructions must be considered as part of the equipment and must not be
separated from it. Therefore, keep it for future reference.
RELATED
DOCUMENTATION
In addition to these instructions, further documentation is available from the
manufacturers of the installed components and is included with the equipment. A
full list of documentation is provided in the
MANUFACTURER DOCUMENTATION
section
AND SUBCONTRACTORS
.
CONTACT US
MANUFACTURER
In practice, there are also unforeseen situations that could not be included and
described in this manual. Therefore, always contact the manufacturer if you are
unsure of the procedure:
G&G filtration CZ, s.r.o.
Hrubínova 1903/9
664 51 Šlapanice
Czech Republic
T: +420 725 745 300
