6
5
3.8.6 Computer can control balance though RS232. The orders to
balanc eare:
1BH+70H: sending data
1BH+71H: calibration (like “CAL”)
1BH+72H: count function (like “COUNT”)
1BH+73H: Units change
1BH+74H: Tare
4. Structure
5. RS232 Data output demonstration
6. Cautions for operation
6.1 Using environment: indoor, max. Altitude: 2000m, temperature:
0-40
℃
, humidity 80%, Power fluctuations less than ±10%
6.2 The electronic scale is a precision instrument which needs to
begently handled during the weighing of articles. Avoid impact and heavy
load on top (never exceed its max. weighing limit). Any forms of impact
or overloading many cause permanent damage to the electronic balance,
even in the use of electronic balance without power supply.
6.3 Place the scale on a firm table for operation, and make sure that the
operating environment of the balance is free of great vibration and
interference of powersupply, and of corrosive gases and liquids.
6.4 Ensure the warm-up time after power-on..
6.5 Warning: If the equipment is used in a manner not specified by this
instruction the projection provided by the equipment may be impaired
7. The Warranty
7.1 We provide warranty within the scope of the statutory regulations,
however we are entitled to either repair or replace the defectiv eproduct.
7.2 Within two years after purchase, the producer offers a free repair
service to all G&G Product, which become defect under proper usage without
human damage. The customers are kindly requested to mail the product as
well as its original proof of purchase to the producer. Notification of defects
and complaints shall be made in writing after the delivery has been received
at the point of delivery. For legitimate notifications of defects and warranty
cases we are entitled at our own discretion to either replace the delivery at
the prices which were valid at the time of the complaint or to rectify the
defect.
7.3 We have the right to try to replace the defective product at most
twice. There will be a slight charge for the repair service of those products,
(1) Scalepan
(2) Display window
(3) Levelindicate
(4) Counting indicate
(5) lb indicate
(6) kg indicate
(7) CAL
(8) COUNT
(9) TARE
(10) PRINT
(11) UNIT
(12) ON/OFF switch
(13) Data output
(14) Power line
(15) Level adjust
