Page 14 of 17
Step #15
(Grip Assembly)
Locate the black grip (J01-4375-000).
Push this grip onto the end of the Shut-Off Lever as shown in Diagram #24.
Diagram #24
2836-T9
Step #16
(Hitch Pin)
Use supplied hitch pin &clip (490894-3) to connect to implement.
Diagram #25
2836-T9
17. Spread Plate Adjustment:
As shown in Step #12 Diagram #21, connecting the spread plate chain to the center hole on the hitch is a good
starting point for most material being applied t
o produce a “Sheet
-
Like” flow coming off the spread plate.
Depending on your application rate and weight of the product being applied you may need to adjust the angle
up or down so the material flows freely off the spread plate.
If application without spread plate is desired, lift spreader up and swing spread plate to the lift handle side of
the spreader and hook the s-hook on the sash chain over the lip on the spreader.
See operator’s manual for more information.
18. Please read Operators Manual for overview of proper use, maintenance & cleaning of spreader.
