Page 9 of 17
Step# 7
(Hitch to Hopper Assembly)
1.
Note:
Lay something down (piece of cardboard or blanket) to protect hopper from being scratched up.
Lay hopper on its side so the cam gauge is up & pivot the spread plate down out of the way as shown in
Diagram #16.
2. Remove the 5/16
”
flange nut from the stud above and to the right of the cam gauge as shown
in Diagram #16.
3. Attach the hitch tube with shut-
off lever in place to the 5/16” stud
& re-use the 5/16
”
flange nut.
Make sure the end of the shut-off lever goes into the U-notch as shown in Diagram #17.
Do not tighten, leave nut loose.
Diagram #16
Diagram #17
2836-T5
