Basic functions
11
Data logger Klima 20 / 30
2 Basic functions
2.1
Commissioning
Before commissioning the data logger, take it out of the package, remove the
screen protection film and check, whether a full CR2032 battery (3 volts) is
insert.
After inserting the battery the device display the actual measurements for a
few seconds.
Afterwards the device shows “F5” for 30 seconds. Then, the
device turns off. The same happens after pressing any button.
2.2
USB-Port
To configure the data logger Klima 20 / Klima 30, connect the computer with
the data logger by using the USB-cable. Start the suitable GANN software
dialog D+ and connect the data logger with the computer by using the USB
cable MK 26. The detailed description can be found in the software dialog D+
package.
Display indication after pressing a
button
Display indication
