Application notes and equipment
17
Data logger Klima 20 / 30
3.4
Storage conditions
Data loggers Klima 20 and Klima 30 may only be stored in the packaging that is
supplied by us (also available as accessory). We will not assume any liability for
damages, caused by non-compliance, to a device or the sensor system that is used in
it. Fumigation from foam materials that have not been supplied by us may damage the
sensor system and lead to falsified measuring values. Therefore it is particularly
important that the device is not stored in such a material.
4 Application notes and equipment
4.1
General notes (Klima 30)
The data logger Klima 30 has an internal sensor. It is also possible to connect
an external temperature sensor. The temperature NT 3 as well as the
temperature sensor NT 8 are can be connected by using the USB port. By
connecting one of these sensors it is possible to measure the temperature of
materials of all kind.
4.1.1
External temperatre sensor NT 3 & NT 8 (Klima 30)
The temperature sensor NT 3 or NT 8 can be connected to the data logger
Klima 30 through the USB port. The temperature sensor is automatically
recognized by the data logger after connecting.
For the measurement, it is necessary to drill a hole into the material. The
temperature sensor can be tucked in for the measurement of the temperature.
The cable of the NT 3 is 3 meters long; the cable of the NT 8 is 8 meters long.
4.1.2
Wall mount
In order to make convenient measurements, there is a wall mount for the data
logger Klima 20 and Klima 30.
Um bequeme Messungen vollziehen zu können, gibt es einen Wandhalter für
den Datenlogger Klima 30. By mounting the data logger in a wall mount you
can be sure that the data logger is always exposed to the same conditions for
example the same air flow etc. The wall mount is magnetic at the backside or
can be screwed or sticked into the wall.
