Introduction
4
Data logger Klima 20 / 30
0.1
Publication statement
This publication replaces all previous versions. It may not be reproduced in
any form or processed, duplicated or disseminated using electronic systems
without the written permission of Gann Mess- u. Regeltechnik GmbH. Subject
to technical and documentary changes. All rights reserved. This document was
prepared with the required care. Gann Mess- u. Regeltechnik GmbH accepts
no liability for errors or omissions.
GANN Mess- u. Regeltechnik GmbH, Gerlingen, Germany. 27/02/2014
0.2
General notes
This measuring device fulfils the requirements of the applicable European and
national directives (2004/108/EC) and standards (EN61010). Appropriate
declarations and documentation are held by the manufacturer. To ensure
trouble-free operation of the measuring device and operational reliability, the
user must carefully read the operating instructions. The measuring device may
only be operated under the climatic conditions specified. These conditions can
be found in Chapter 3.1 "Technical data". This measuring device may likewise
only be used under the conditions and for the purposes it was designed for.
Operational reliability and functionality are no longer ensured if the device is
modified or adapted. Gann Mess- u. Regeltechnik GmbH is not liable for any
damage arising from such modifications or adaptations. The risk is borne by
the user alone.
Using appropriate means, make always sure that there are no
electrical cables, water pipes, or other utility lines at the location, at
which the measurement is to be carried out.
The device must not be stored or operated in aggressive air or air
containing solvents!
Material that is frozen or has wet surfaces cannot be measured.
The notes and tables in these instructions on permitted or normal
humidity conditions in practice and the general definitions of terms
have been taken from the specialist literature. No responsibility can
therefore be taken by the manufacturer for the correctness of this
information. The conclusions to be drawn from the measurement
