ENGLISH
9
the machine down when the tank is full (
they also detect the level of
any foam present
).
4.4.
After finishing the work or when the solution in the tank is used up
(indicated with a red flashing light on the switch board), stop brush
rotation by pressing the corresponding button. This also stops the
flow of water. Raise the head using the pedal.
4.5.
To collect the remaining dirt, continue for a further 3-4 metres with
suction activated and the squeegee lowered, than turn both
functions off by pressing the suction button and raising the
squeegee lever. This empties all water left in the circuit into the
collection tank.
IMPORTANT
!
After you have finished cleaning, you are recommended to raise the
tank lid and turn the suction motor on again for a few minutes. The
dry air sucked in will evaporate any remaining moisture, extending
the working life of the motor.
4.6.
Empty the collection tank into a container or drain using the black
drain hose and proceeding as follows:
-
detach the hose from the control panel;
-
keeping the hose raised above the level of the tank at all times
,
remove the cap;
-
lower the hose gradually towards the container.
4.7.
IMPORTANT!
After each cleaning session, you are recommended
to drain the dirty water and rinse the tank to avoid unpleasant
smells or the formation of harmful germs.
To make this operation
faster, simpler and more effective, the appliance is fitted with
an exclusive system:
-
the tank tilts backwards, after raising the lid, lift the tank until it rests on
the chassis (empty before tilting);
-
after removing the cap, lower the drain hose to allow the water to run
off rapidly;
-
wash the collection tank with running water;
-
leave the tank tilted until the next time you use the machine.
The appliance has been designed to facilitate thorough maintenance.
A little attention improves the efficiency of your appliance and
extends the already long working life.
