GAT ECO.Side Lock 7000 BA / NW BA
Configuration
www.gantner.com
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
39
5
CONFIGURATION
5.1 General Information
The GAT ECO.Side Lock 7000 BA is configured using a PC/laptop and GAT Config Manager software. The
configuration file must only be uploaded to the GAT ECO.Side Lock 7000 BA once. The configuration file for the first
lock in the system is saved in GAT Config Manager and can then be uploaded to each lock that requires the same
configuration. Locks that require a different configuration need a separate configuration file to be made in GAT
Config Manager.
NOTE!
After importing the configuration file to the first lock, complete an operational test to ensure the data carriers
(MASTER and standard) and general lock functionality perform as required.
The following data is imported into the GAT ECO.Side Lock 7000 BA during configuration:
-
Site key
-
Sub-site number
-
Locker number
-
Operating mode of the GAT ECO.Side Lock 7000 BA
(“free locker”, “free locker universal”, “free locker unique
number”, “personal locker programming card”, or “personal locker expiry date”. See section “6.3 Operating
Modes
-
Free Locker: Sector number of the data on the data carrier and the time setting for "limited duration of use"
function
-
Date and time (set automatically)
-
Unique numbers of the MASTER data carriers (and OPEN MASTER data carriers, if used)
The MASTER data carriers and OPEN MASTER data carriers can also be directly programmed into the GAT
ECO.Side Lock 7000 BA
(see section “6.5.1 MASTER Data Carrier”). However, the most efficient way to
program the data carrier numbers into multiple locks is via PC and GAT Config Manager.
NOTE!
The GAT ECO.Side Lock 7000 BA does not set the daylight-saving time automatically. Time changes due to
daylight saving must be considered when evaluating bookings and when authorizing data carriers with expiry
dates/times.
5.2 Setup for Configuration in GAT Config Manager
Once the battery is installed in the GAT ECO.Side Lock 7000 BA
(see “4.2.2. Inserting the Battery”), the USB cable
connected from the lock to the computer (see “4.3. USB Connection”), and the SERVICE
data carrier used to
activate configuration mode (see “6.5.4 SERVICE Data Carrier”), the settings can be viewed and configured using
GAT Config Manager.
There is a separate manual with detailed information on each function available in GAT Config Manager. To
access the manual while the software is open, click on the “Help” drop-down menu and select “How Do I”.
Summary of Contents for GAT ECO.Side Lock 7000 BA
Page 63: ......
