GAT ECO.Side Lock 7010 (NW) F/ISO
Operation
www.gantner.com
HB_GAT-ECOSide-Lock7010-FISO--EN_11
57
6.5.5
BATTERY Data Carrier
After the battery is replaced in the GAT ECO.Side Lock 7010 F/ISO, the lock is in battery replacement mode and
must be returned to the normal operating mode using the BATTERY data carrier. The internal action counter is
reset to zero when the BATTERY
data carrier is used. See section “4.2.3. Replacing the Battery” for more
information.
After replacing the batteries of a GAT ECO.Side Lock 7010 F/ISO in personal locker mode, all settings stored
in the lock remain as previously configured.
6.5.6
SERVICE Data Carrier
The SERVICE data carrier is used to put the GAT ECO.Side Lock 7010 F/ISO into configuration mode after the lock
is connected to a computer via USB (see section “4.3 USB Connection”). The settings of the GAT ECO.Side Lock
7010 F/ISO
are configured using GAT Config Manager while the lock is in configuration mode (see “5
When the GAT ECO.Side Lock 7010 F/ISO reads the SERVICE data carrier without being connected to a PC via
USB cable, an antenna calibration is performed, which locks the lock for a few seconds. After locking, the LED
flashes red and the SERVICE data carrier must be removed. The antenna is calibrated and the LED flashes green.
Finally, a green LED and sound signal are emitted to indicate that the antenna calibration has been performed
successfully. The locker is then unlocked if it was locked before the calibration.
NOTE!
The SERVICE data carrier must be available for technicians who are required to configure the locker
system. Without the SERVICE data carrier, system configuration is not possible!
6.5.7
APP KEY Data Carrier
The APP KEY data carrier is required if you want to configure a GAT ECO.Side Lock 7010 F/ISO with the MoLA app.
This app is installed on a mobile device. When the device is in factory mode and configured for the first time, the APP
KEY is not needed, but for later configuration changes you need the APP KEY data carrier (see also "5.3 Configuration
with the MoLA App").
To configure the GAT ECO.Side Lock 7010 F/ISO with the GAT Config Manager, the APP KEY data carrier is
not necessary.
Summary of Contents for GAT ECO.Side Lock 7010 F/ISO
Page 63: ......
