GAT ECO.Side Lock 7010 (NW) F/ISO
Installation
www.gantner.com
HB_GAT-ECOSide-Lock7010-FISO--EN_11
17
3
INSTALLATION
This chapter describes the process and what must be considered to install the GAT ECO.Side Lock 7010 F/ISO and
GAT ECO.Side Lock 7010 NW F/ISO into lockers with metallic, non-metallic, and glass doors. Since the mounting
process is identical for both lock variants, the general term GAT ECO.Side Lock 7010 F/ISO is used.
Risk of damage or failure to the GAT ECO.Side Lock 7010 F/ISO
-
Read the information in this section carefully before installing the GAT ECO.Side Lock 7010 F/ISO.
-
Carefully observe the installation diagrams.
-
Use the correct tools to install the GAT ECO.Side Lock 7010 F/ISO.
3.1 Target Group
This chapter provides information for technicians who install the GAT ECO.Side Lock 7010 F/ISO. Experience in
mechanical work and basic electrical knowledge is required. Previous knowledge of the GAT ECO.Side Lock 7010
F/ISO is not required.
3.2 Definition of the Door Hinge (Right of Left Door)
For installation, it is important to determine whether the door is hinged to the left or the right. This is defined as follows:
Figure 3.1
– Locker door hinge definition (left/right)
In the following pages the installation for right-hinged doors is described. The installation process for left locker doors
is in principle the same as for right locker doors, only with reversed lock and door orientation.
NOTE!
If spring hinges are used in the locker door, ensure that the spring strength is calibrated to allow correct
operation of the lock. For example, springs that are too strong can keep the bolt set permanently held in thereby
activating the lock’s electronics and draining the battery.
Summary of Contents for GAT ECO.Side Lock 7010 F/ISO
Page 63: ......
