GAT ECO.Side Lock 7010 (NW) F/ISO
Commissioning
www.gantner.com
HB_GAT-ECOSide-Lock7010-FISO--EN_11
33
4
COMMISSIONING
4.1 Target Group
This chapter provides information for technicians responsible for putting the GAT ECO.Side Lock 7010 F/ISO and
GAT ECO.Side Lock 7010 NW F/ISO into operation. A base knowledge of electronics is assumed. Previous
knowledge of the GAT ECO.Side Lock 7010 F/ISO is not required. Since the comissioning process is identical for
both lock variants, the general term GAT ECO.Side Lock 7010 F/ISO is used.
4.2 Power Supply
4.2.1
Battery Information
The GAT ECO.Side Lock 7010 F/ISO is powered by one 3.6 V AA Lithium battery
(see “8. TECHNICAL DATA”).
The battery life span is designed around a defined number of locking cycles. The actual life span depends upon the
number of locking cycles (usage frequency of the lock) and the environmental conditions. The battery must be
replaced when the battery voltage becomes too low. If the battery becomes too weak, the locker can no longer be
locked. The GAT ECO.Side Lock 7010 F/ISO indicates a weak battery state with five red flashes of the LED and five
acoustic signals during a locking attempt.
NOTE!
For optimal battery lifespan, use the approved battery available from GANTER (EU: Battery 3,6V
Lithium Tadiran SL-860/S, Part No. 914430 or for US: Battery 3,6V Lithium Tadiran TL-4903/S).
4.2.2
Inserting the Battery
Before putting the GAT ECO.Side Lock 7010 F/ISO into operation, the battery must be inserted into the battery
compartment.
NOTE!
To avoid unnecessary battery usage, insert the battery directly before the GAT ECO.Side Lock 7010
F/ISO is installed.
► To access the battery compartment, remove the red battery cover (1 in Figure 4.1) on the underside of
the housing by sliding a finger under the tab section of the battery cover.
Summary of Contents for GAT ECO.Side Lock 7010 F/ISO
Page 63: ......
