System Setting
74
|
System Setting
\
\
Motion Sensor
You can set an action to execute when a motion is detected.
For the settings of the motion sensor, move to <
CAMERA SETUP
>.
1.
From <
SYSTEM SETUP
> - <
EVENT
>, select
<
MOTION SENSOR
>.
2.
Use the [
▲▼
◀▶
] buttons on the remote control or
use the mouse to specify the ignorance interval and
operation.
i
IGNORING INTERVAL : Specify the minimum
interval of the motion event occurrence.
For example, even if you have set the minimum
frequency to 5 seconds and another motion event
occurs in less than 5 seconds after the last motion
event occurred, the new event will be ignored. If
too many motion events occur, adjust to shorten
the interval.
Motion recording will be triggered immediately after the motion occurred regardless of the above settings.
i
ALARM OUTPUT : Specify the alarm output channel if a motion is detected by the motion sensor.
i
: Specify the output of the buzzer if a motion is detected by the motion sensor.
i
: Select to display the video popup if a motion is detected by the motion sensor.
i
: Select to send an email if a motion is detected by the motion sensor.
i
: Select whether to upload event notification onto the FTP upon detected motion event.
3.
To apply the change, click <
APPLY
> in the bottom of the screen.
4.
When done, press the [
EXIT
] button on the remote control or click <
CLOSE
> in the lower screen. The confirmation
message appears and you will return to the previous menu.
