３６
System Setting
S.M.A.R.T settings
You can check the S.M.A.R.T information of the disk and specify the check frequency.
What is S.M.A.R.T information?
S.M.A.R.T (Self-Monitoring, Analysis and Report Technology) is to detect a HDD that is likely to
cause a problem in the future with a warning message.
2U model (DR8/16FX5) supports both
<INTERNAL>
and
<EXTERNAL STORAGE>
.
1. From
<SYSTEM SETUP> - <STORAGE
>,
select
<S.M.A.R.T. SETUP>
.
2. Use the
[▲▼
◀▶
/ENTER]
buttons on the remote
control or use the mouse to check the S.M.A.R.T
operation and specify the check interval.
>S.M.A.R.T STATUS : Read the S.M.A.R.T
information of the disk and check to display if the
current disk is in normal operation.
Click
<DETAIL INFO>
to view the details.
- NORMAL : The disk is in a normal state.
- CHECK : The disk has an error so that you need
to check the disk or the connection cables of the
disk. If you leave the problem unresolved, no
recording may be enabled.
So it is recommended that you replace the disk
immediately.
- ERROR : The disk fails or is unable to use due to
an error of the disk or the cable.
The disk should be replaced immediately.
Contact the retailer or the customer service to replace the disk.
S.M.A.R.T CHECK INTERVAL : Specify the S.M.A.R.T check interval. Click
<CHECK NOW>
to start checking.
3. To apply the change, click
<APPLY>
in the bottom of the screen.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE>
button.
The confirmation message appears and you will return to the previous menu.
