４２
System Setting
Motion Sensor
You can set an action to execute when a motion is detected.
For the settings of the motion sensor,
move to <CAMERA SETUP>.
1. From
<SYSTEM SETUP> - <EVENT>
, select
<MOTION SENSOR>
.
2. Use the
[▲▼
◀▶
]
buttons on the remote control
or use the mouse to specify the ignorance interval
and operation.
>IGNORING INTERVAL : Specify the minimum
interval of the motion event occurrence.
For example, even if you have set the minimum
frequency to 5 seconds and another motion event
occurs in less than 5 seconds after the last motion
event occurred, the new event will be ignored.
If too many motion events occur, adjust to shorten the interval.
Motion recording will be triggered immediately after the motion occurred regardless of the
above settings.
>ALARM OUTPUT : Specify the alarm output channel if a motion is detected by the motion sensor.
>BUZZER : Specify the output of the buzzer if a motion is detected by the motion sensor.
>VIDEO POPUP : Select to display the video popup if a motion is detected by the motion sensor.
>EMAIL : Select to send an email if a motion is detected by the motion sensor.
>FTP : Select whether to upload event notification onto the FTP upon detected motion event.
3. To apply the change, click
<APPLY
> in the bottom of the screen.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE>
in the lower
screen. The confirmation message appears and you will return to the previous menu.
Video Loss
You can specify a reaction to the case where no video is received from the camera.
1. From
<SYSTEM SETUP> - <EVENT>
, select
<EVENT LOSS>
.
2. Use the
[▲▼
◀▶
]
buttons on the remote control or
use the mouse to specify the reaction to a video loss.
>ALARM OUTPUT : Specify the alarm output
channel if a video loss occurs.
>BUZZER : Specify the output of the buzzer if a
video loss occurs.
>EMAIL : Select to send an email if a video loss
occurs.
>FTP : Select whether to upload event notification onto the FTP upon detected video loss
event.
3. To apply the change, click
<APPLY>
in the bottom of the screen.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE>
in the lower
screen. The confirmation message appears and you will return to the previous menu.
